How to use and maintain the rubber vulcanizing press?

Rubber vulcanizing machine is suitable for the vulcanization of various rubber products. It is advanced hot pressing equipment for pressing various thermosetting plastics. The rubber vulcanizing press is divided into three types: electric heating, steam heating, and oil heating. The following is an introduction to the use and maintenance of the rubber vulcanizing press.

Here is the content list:

●How to use a rubber vulcanizing press?

●How to maintain the rubber vulcanizing press?

How to use a rubber vulcanizing press?

1. Control wiring board: first connect the 220V power cord to the wiring board at the back of the control box, and plug the three output cord plugs of the control box into the left, middle, and right of the rubber vulcanizing press, respectively, into the left heating plate, lower heating plate and right heating of the rubber vulcanizing press. On the socket of the board.

2. Both ends of the thermocouple: connect the two ends of the thermocouple to the temperature measuring terminal of the rubber vulcanizing press and the control box respectively.

3. Fixing of the template: put the same template as the tire type in the vulcanization tank of the rubber vulcanizing machine, install the rubberized tire on the airbag and put it into the vulcanization tank, put the corresponding upper hatch, and then place the weight, move the handwheel to tighten the pressure screw, and then fill the airbag with a proper amount of compressed air.

4. The power switch on the electric box: turn on the power switch on the electric control box, the indicator light is on, indicating that the power is on, and then adjust the set temperature dial on the electric control box to point to the required temperature.

5. Temperature selection and setting: turn on the heating switch on the electric control box, and the rubber vulcanizing machine will start to heat up. When the temperature rises to the set temperature, it can automatically cut off the power to maintain a constant temperature. When the temperature is lower than the set temperature, you can turn on the power by yourself.

6. Continue heating operation: this cycle, automatic control, after the vulcanization time, turn off the power switch.

7. Release air and mold forming: after the temperature of the rubber vulcanizing press is lowered, release the air in the airbag, loosen the upper compression screw, and then the tire can be unloaded, and the whole vulcanization process is completed.

How to maintain the rubber vulcanizing press?

Before using the rubber vulcanizing press, carefully check whether all parts are firmly connected, and check whether the electrical wiring is correct. In addition to regular cleaning of the appearance of the equipment, oil should be frequently added between the column guides to maintain good lubrication. The working oil in the oil storage tank of a rubber vulcanizing press should be filtered every three months to remove impurities in the oil. After the oil has been used for one year, the oil should be replaced with a new one. The valve core and valve seat of the control valve of a rubber vulcanizing press must be removed and finely ground at least once a year. The valve core and valve seat of the control valve should be removed and finely ground at least once a year.

Qingdao Huicai Machine Manufacture Co., Ltd has become a professional rubber machinery manufacturer and exporter in China and has produced many rubber vulcanizing presses with great quality. If you want to buy a rubber vulcanizing press, you may want to consider using our products.